DESCRIZIONE
Class D dual mono power amplifier based on HYPEX NC500 modules. Thanks to the Ncore technology the amplifier is ultra-linear, low noise and distortion (even lower than those typical of the A class or A / B of the highest quality) and also can handle the most difficult loads thanks to an ultra-low output impedance. For the dual mono design each channel has one NC500 amp board powered with one Hypex SMPS1200A700. The I/O board of each NC500 is the baseline produced by Hypex (NC500 converter) with LM4562 op-amps and LDO voltage regulators (LM7815/7915). To increase the performances it's possible to swap the LDO with the HxR voltage regulators. Balanced inputs.
NEUTRAL AND CLEAR POWER AMPLIFIER
I/O BOARD HYPEX UPGRADABLE WITH HxR VOLTAGE REGULATORS
BASIC I/O BOARD
NC500 CONVERTER
This i / o board realized by Hypex has the advantage of not bringing any color to the audio signal.
The buffer stage uses the LM4562 op-amps with the LDO voltage regulators.
The overall gain (in combination with the NC500 module) is 26db.
The input impedance is 47Kohm.
BASIC I/O BOARD HxR
NC500 CONVERTER + HxR
It is possible to increase the performances of the basic I / O board by replacing the LDO voltage regulators with the Hypex HxRs. In this way, the following improvements are achieved:
-
ultra low noise
-
higher bandwidth
-
excellent CMRR
-
low output independent load impedance
SPECIFICATIONS
-
Ouput power: 2x550W(2Ω), 2x700W (4Ω), 2x400W (8Ω)
-
Distorsion THD + N: 0,005% (20Hz<f<20kHz, 4Ω. Pout<PR/2)
-
Power Bandwidth min. 35Khz
-
Frequency Response 0-50Khz (+0/-3dB. All loads.)
-
Voltage Gain: 26db
-
Input Impedance: 47Kohm
-
SNR 135db
-
PSRR 85db
-
Output noise 25μV
-
CMRR 65db all frequency
-
Maximum output current: 28A
-
High Line Input Voltage: 190-250Vac
-
Low Line Input Voltage: 95-130Vac
RCB OPTION . It is possible to install, for each channel, the RCB (Rouge Connection Board) which allows to have double XLR and RCA inputs. It is a passive module made with quality components.
CHASSIS: black metal chassis with silver alu front panel
SIZE: 435x300x80mm
WEIGHT: 9Kg
INPUT: 2 XLR
FUSE 250V/10A (5x20mm)
ACCESSORIES: standard power cable IEC/SHUKO
_clipped_rev_1.png)
